Name: Joe Guo
Tel: 0086-796-8799911
Fax: 0086-796-8799911
Mobile: 0086-13666839043
E-mail: [email protected]
E-mail: [email protected]
Add: Kanmen Science&Technology park,Yuhuan,Taizhou,Zhejiang,China
Skype: joe2589
WeChat: joe2589
whatsapp: 0086-13666839043
QQ:
273592256
Step 1 – Take off the Wheels
To enable you to install control arm bushings, take off the wheels first by taking off the hubcaps and then loosening the bolts in the front wheels.
Step 2 – Placing Jack Stands
It will be difficult to work if you do not bring your car up. Use the jack to bring the front part of the car up and then replace them with jack stands. When you do so, make sure that they are properly secured so that the car will not suddenly go down while you are working.
Step 3 – Remove the Wheels and the Nuts
Take out the wheels and set them aside. Next, remove the nuts in the sway bar drop link. Remove the bolts in the rear control arm bushing brackets as well as those in the inner and outer ball joints. The latter will require some work before they can be removed. Use a splitter tool to remove the outer ball joints or you can simply punch them.
Step 4 – Take out the Lower Control Arm
When you are in the process of removing the lower control arm, be sure to keep them in exact adjustment that they are set. Remove the control arm, including the shims, if it uses one, and place them on the ground together. This is to make it easier to place them back the way they were removed. If it uses an eccentric instead, be sure to remember where the position is by marking them.
Step 5 – Remove the Control Arm Bushings
Take off the steel brackets from your control arms. Cut the steel ring of your old control arm bushings but do not go through the steel brackets. Bend the steel ring and hammer out the old control arm bushings to get them out of the bracket.
Step 6 – Center the New Control Arm Bushings on the Bracket
Align the bushings to the marks on the bracket and secure them into place by using a shop press or a bench vice.
Step 7 – Install the Control Arm Bushings
Make sure that you do this fast because the bushings will stick to the control arm. Heat the bushings and lubricate them with liquid dish soap, then put them into place.
Step 8 – Place Everything Back
Put back all the components that you have removed – the lower control arm, bolts and nuts, and the wheels.